Recently, I just changed the great product motherboard, and identified that the SATA hard disk perfo

diskgetor ntfs recovery changed, the really hard drive is Apacer TurboIIISeries-AS710, SATA3.0 interface.

The best way to verify the operating mode of your tough disk you use? The strategy is quite basic, initially enter the BIOS, check the SATA tough disk functioning mode. The second is always to make use of the ASSSDBenchmark software program. When the word “OK” is displayed in the red box in the upper left corner with the software, it means that the really hard disk operates in AHCI mode. In the event the word “BAD” is displayed, it implies that the really hard disk operates in IDE mode.

The current mainstream really hard drives are all SATA interfaces. SATA challenging drives can operate in IDE or AHCI mode. Of course, the efficiency of AHCI mode is significantly larger than that of IED mode. To turn on AHCI mode, you have to turn on the BIOS. In case you are installing Win10 program The AHCI mode has not been turned on in the BIOS ahead of. Then the Win10 method will operate in IDE mode, that will tremendously influence the work efficiency from the hard disk. In the event the SSD solid state drive is just not turned on in AHCI mode, the efficiency effect are going to be higher.

If the BIOS is straight changed to AHCI mode following the program is installed, it can result in the technique to fail to start (as shown within the figure above), so how can the AHCI mode be turned on typically?

Windows ten can change the functioning mode of SATA hard disk from IDE to AHCI with out modifying the registry:

Initial, add Win10 protected mode towards the method boot menu, the certain operation approach is as follows:

1. Press WIN + X and after that open the 'Control Panel'.

2. Pick out in turn: Manage Panel --- All Manage Panel Products --- Power Possibilities.

3. Choose the function solution from the power button.

4. Click 'Change the at the moment unavailable settings', and close the swift start (turning off the swift start out is actually a prerequisite for restoring the F8 into advanced startup); (Supplement: Though that is introduced on the net, in truth, often it can be probable not to turn off the rapid get started . At least in this experiment, the test platform I employed doesn't want to close the rapid start out, you could nevertheless press F8 to enter the advanced startup alternatives.)

five. Press recover deleted ntfs partition [Win] + [X] shortcut crucial, pick the 'Command Prompt (Administrator)' alternative inside the shortcut menu, enter 'bcdedit / set default bootmenupolicylegacy' inside the English state and press Enter.

six. Restart the laptop or computer, press F8 soon after booting, it is possible to see the conventional protected mode solutions.

7. Right after confirming that the protected mode could be entered generally, restart the personal computer, locate the tough disk controller mode setting solution inside the BIOS (look for the setting options containing the words SATA, IDE, AHCI), and change the really hard disk mode from IDE to AHCI.

eight. Save the alterations and restart the laptop. Please note that you simply have to enter protected mode very first!

9. After successfully entering protected mode, restart the computer system and select typical startup. Beneath regular circumstances, it can be ordinarily started. At this point, the switch on the really hard disk mode from IDE to AHCI is completed.

At this time, use the ASSSDBenchmark software program to view, you'll be able to see that the 'iaStorA-OK' is displayed within the red box in the upper left corner from the software program, indicating that the hard disk has been working in AHCI mode at this time.